Ok, some of you keep asking, so here you go... *Warning* This thread contains no airsoft ;)

The pouch is not for four magazines, it is for only three.

The first pic shows the pouch opened:



The black thing furthest away is the cleaning kit (in its pouch) in the little side pocket, the 3 bakerlite AK74 mags are obvious and the fourth mysterious pocket holds 4 stripper/charger clips (they fit in the loops you can see inside this pocket) and a loading tool, over which the little leather strap fasten to hold it in place.

Next pic shows one stripper/charger removed and laid next to the loading tool:



Next pic shows how you place the loading tool over the open end of the stripper/charger, which depresses a spring clip allowing you to slide in fifteen 5.45x39 rounds:



Thats half a mag's worth ;)

The loading tool is removed from the stripper/charger and the spring clip pings up and the fifteen rounds are locked in the stripper/charger and cannot fall out:



These are then placed the fourth cell of the mag pouch.

Lastly, to load a mag with the stripper/charger the loading tool is reattached, and its wide end slides into the grooves cut in the bakerlite magazine like this:



You can see the grooves I am on about if you look at the mag lying down bottom right - the little white line...

One firm push down and fiften rounds go into the mag in a flash, two strips and you have an entire mag.

With the four charger/strippers in your pouch you have another 60 rounds or two mags to supplement your 3 initially loaded mags. Further ammo in cardboard boxes may be carried in backpacks, pockets etc etc.

Hope this has helped you all Comrades!

PS yes, I know those are DDR mags ;)

The four stripper/chargers back in their storage loops and the loading tool sitting back where it goes, just waiting for the strap to be fastened back across it.

Autor cytatu: yakarovNo ja tez nie wiem ;) może jakaś taka dodatkowa kieszonka w stylu jak na łódkę albo takie szlufki jak w ładownicy do SWD.
Bo w AKS-74U nie ma wyciora. Więc logicznym byłoby dodanie go do ładownicy tak jak to ma miejsce w SWD. Więc tak się zastanawiam.